Hardware processing operation steps
Published on:
2021-11-22
Hardware processing; operating procedures
1. Hardware processing; before entering work,. All employees should check that their clothing meets job requirements. Slippers, high heels and clothing that compromise safety are not permitted. People with long hair should wear hard hats. Maintain the correct posture at work and have enough energy to cope with the work. If you find yourself unwell, . You should leave immediately and report to leadership. When operating, you must concentrate your thoughts, prohibit small talk, and cooperate with each other. Operators should not operate in a state of irritability and fatigue. To avoid accidents and ensure safe operation.
2. Hardware processing; check whether the moving parts are full of lubricating oil before mechanical work. , and then start to check whether the clutch and brake are normal, run at idle speed for 1-3 minutes, and prohibit operation when there is a mechanical failure.
3. When replacing the mold, turn off the power first, and then install and debug the mold after the moving part of the punch stops running. After the adjustment is completed, move the flywheel by hand to make two test punches to check whether the upper and lower molds are symmetrical and reasonable, and whether the screws are firm. Whether the blank holder is in a reasonable position.
4. It is necessary to wait for all other personnel to leave the mechanical work area and take away the sundries on the workbench. Only then can the power supply start the machine.
5. After the machine is started, one person should carry the material and operate the machine. Others must not press on the electrical floor or the foot switch board. Do not put your hands on the mechanical work area or touch the moving parts of the machine. . When working, it is strictly forbidden to put your hand into the working area of the slider, and it is strictly forbidden to hold the workpiece by hand. When picking and placing workpieces in the mold, . Standard compliant tools are required. If you find any abnormal sound or malfunction of the machine, you should immediately turn off the power switch for inspection.
6. After get off work, the idle power supply should be turned off. And sort out the finished products, scraps and sundries on the post. , to ensure a clean and safe working environment.
The above operating rules need to be consciously followed. . Don't break the rules and regulations. In the event of a failure, the maintenance personnel should be coordinated for overhaul. In the event of an accident, immediately cut off the power supply. Keep on-site reporting to the factory department for processing. All the consequences caused by the violation of the operating procedures shall be borne by the parties concerned.
Relevant News
Sheet metal processing production process
2022-07-06
Jiangsu Songshi metal products Co., Ltd
E-mail：jsss_metal@163.com
Address: No. 32, Haiyan Road, Qidong high tech Industrial Development Zone, Jiangsu Province
Copyright © 2022 Jiangsu Songshi metal products Co., Ltd.